Frictional Games Forum (read-only)

Full Version: [Help] Second Level Trouble
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2
I'm having some trouble setting up the second level of Part 1. When I say level, I mean building story.

I have no clue what I did wrong, but I see some clipping errors in the room under the second story Guest Bedroom hallway.

http://www.mediafire.com/?an8gq1mz6f88vt8
Anyone gonna help?
(12-26-2011, 08:23 AM)Vipes Wrote: [ -> ]Anyone gonna help?
I don't know what you need help with.

(12-26-2011, 09:12 AM)flamez3 Wrote: [ -> ]
(12-26-2011, 08:23 AM)Vipes Wrote: [ -> ]Anyone gonna help?
I don't know what you need help with.
I need help setting up a second story to my level.

(12-26-2011, 07:19 PM)Vipes Wrote: [ -> ]I need help setting up a second story to my level.

By "story" do you mean a second floor or part of the storyline?
(12-26-2011, 07:55 PM)Your Computer Wrote: [ -> ]
(12-26-2011, 07:19 PM)Vipes Wrote: [ -> ]I need help setting up a second story to my level.

By "story" do you mean a second floor or part of the storyline?
Second floor for Part 1.
(12-26-2011, 09:12 PM)Vipes Wrote: [ -> ]
(12-26-2011, 07:55 PM)Your Computer Wrote: [ -> ]
(12-26-2011, 07:19 PM)Vipes Wrote: [ -> ]I need help setting up a second story to my level.

By "story" do you mean a second floor or part of the storyline?
Second floor for Part 1.
Put stairs and then put a plane down on the tip of the stairs? I'm still not sure what the problem is Tongue
you can click on the plane and add the "Y position" to make it go higher. or you could go to the bottom of the level editor window to "height" and raise it where necessary and just apply the plane onto the grid.
when you say clipping errors, just double check you haven't duplicated an object and left it in the sam place as the original. doing that will make the object look flashy and unsupported by your graphics card. Smile
and if you mean clipping errors in the way of smoke or flame, i dont think that can be stopped...

Other than that you will have to give more information.
(12-28-2011, 11:44 AM)Tripication Wrote: [ -> ]when you say clipping errors, just double check you haven't duplicated an object and left it in the sam place as the original. doing that will make the object look flashy and unsupported by your graphics card. Smile
and if you mean clipping errors in the way of smoke or flame, i dont think that can be stopped...

Other than that you will have to give more information.
Look at the room with the TV and phonagraph. Now look up on its ceiling. Parts of the hallway above it clip with the ceiling.
Pages: 1 2