01-12-2013, 11:53 AM
I edited the portcullis model in the model editor so items can go in between the bars of the gate, but when I use SetMoveObjectState it goes up as normally but the block box doesn't disappear and it will act as if the gate is still there.
I have little experience with the model editor so I couldn't figure out how to fix it but the original portcullis (which is pretty much the same) still works as it normally would
EDIT:
It seems that when the portcullis goes up it only removes "Body_1"
-Imre
I have little experience with the model editor so I couldn't figure out how to fix it but the original portcullis (which is pretty much the same) still works as it normally would
EDIT:
It seems that when the portcullis goes up it only removes "Body_1"
-Imre